klotz: aprs* + raspberry pi* + ham radio*

0 bookmark(s) - Sort by: Date ↓ / Title / - Bookmarks from other users for this tag

  1. This GitHub repository contains the development of an APRS hub that transmits various sensor data like spO2, location, and altitude. The project uses Raspberry Pi, Tiny Circuit Python boards, and MQTT for data transmission.

  2. this worked.

    2016-05-29 Tags: , , , , by klotz
  3. The normal Debian installation instructions are good, remember to use wheezy as DISTRIBUTION in sources.list:

    http://he.fi/aprsc/INSTALLING.html

    1. If you've installed aprsc by hand before, remember to remove it first. Make a backup copy of aprsc.conf, and "sudo dpkg --purge aprsc". If /opt/aprsc doesn't disappear completely, reboot and "sudo rm -rf /opt/aprsc".

    2. Raspbian does not load IPv6 by default, and the default aprsc configs include dual-stack IPv4+IPv6 configuration (Listens on "::" - all IP addresses). You must load the IPv6 module to run aprsc with this default config:

    sudo bash modprobe ipv6 echo ipv6 >> /etc/modules

    The last command will make the ipv6 module load automatically after a reboot.

    Yes, you need to do that even if you don't really have IPv6 on your network.

    2014-07-25 Tags: , , , by klotz
  4. 2014-05-09 Tags: , , , by klotz
  5. 2014-05-09 Tags: , , by klotz
  6. 2014-05-08 Tags: , , , , by klotz
  7. 2014-05-05 Tags: , , , , by klotz
  8. 2012-09-04 Tags: , , , by klotz

Top of the page

First / Previous / Next / Last / Page 1 of 0 SemanticScuttle - klotz.me: Tags: aprs + raspberry pi + ham radio

About - Propulsed by SemanticScuttle