LILYGO has announced a raft of new microcontroller development boards targeting different niches: a low-frequency LoRa board, an ultra-widescreen display board, a LoRa-equipped ePaper display board, and a CAN bus board. The boards are powered by the Espressif ESP32-S3 microcontroller.
The TCL NXTPAPER 11 Plus tablet features a unique, anti-glare NXTPAPER display designed to reduce eye strain with adaptive brightness and color temperature controls. It boasts a long-lasting 8000mAh battery, 8GB RAM (expandable to 16GB), and 256GB of storage. Equipped with 8MP front/rear cameras, quad speakers, and running Android 15.
The SQFMI Watchy is a fully open-source, hackable ePaper watch based on the ESP32 with a crisp, glare-free 1.54" 200x200 ePaper display which can be programmed using the Arduino IDE and lots of your favourite Arduino/ESP libraries!
SQFMI Watchy, a hackable ePaper watch based on the ESP32.
I've actually just received one of these HATs (the crashing version), and found this issue because my Pi Zero was crashing. Thanks for all the suggestions here.
Instead of messing around with capacitors, wouldn't it be simpler to do this:
remove (clip off / unsolder) the 5V pin(s) from the Pi header
attach the HAT to the Pi
solder a wire from the 3.3v pin to VCC on the HAT
Instead of messing around with capacitors, wouldn't it be simpler to do this:
remove (clip off / unsolder) the 5V pin(s) from the Pi header
attach the HAT to the Pi
solder a wire from the 3.3v pin to VCC on the HAT
