- Discussion about a dedicated timesharing system called SITS (Small Incompatible Timesharing System) used for running Logo and other PDP11/45 programs.
- Mentions of various software and tools such as DDT, Salv, Tinté editor, LISP11, Macro assembler, Link linker, Spacewar, etc.
- Discussion about the General Turtle 2500 standalone Logo machine and its possible use of SITS.
- Mention of a special Logo keyboard similar to Knight or Space-cadet keyboards that may have been used with raster displays.
- Comments on running SITS' Salv to initialize an empty disk, reading files from paper tape using RUG, and starting the system sphere
- Mentions of various software and tools such as DDT, Salv, Tinté editor, LISP11, Macro assembler, Link linker, Spacewar, etc.
- Discussion about the General Turtle 2500 standalone Logo machine and its possible use of SITS.
- Mention of a special Logo keyboard similar to Knight or Space-cadet keyboards that may have been used with raster displays.
- Comments on running SITS' Salv to initialize an empty disk, reading files from paper tape using RUG, and starting the system sphere
Must not be using wayland. Can't find any way to do half this stuff on wayland anyway. Switched back to X11.
LXDE edits are » not going to work, the desktop is now wayland/wayfire not lxde, that guides to old.
edit .config/wayfire you'll see the keyboard shortcuts on the top
edit .config/wayfire you'll see the keyboard shortcuts on the top
First time programming still needs a hardware connection to be made between P1.5 and GND, but after that holding the 1st key while connecting USB lands you in the bootloader!
If your board is never used with ch55xduino before, you need to make the ch55x chip enter bootloader mode. You need to disconnect USB and unpower ch55x, connect the pull-up resistor on D+ line (generally a 10K resistor between D+ and 5V, controlled by a push-button or adjacent pads). Then you connect USB. and hit Upload. Also, a blank new chip will enter the bootloader automatically.
Just go to the iTerms2 preferences -> Profiles -> Keys -> set the Left/Right Option key to Esc+.
