This repository contains a star/planets engine in an Arduino library.
Open-source project showcasing a speech-to-text application on a low-cost CH32V003 microcontroller. The application reads audio from an analog microphone, identifies spoken digits 'zero' to 'nine', and logs the results over a serial link.
Watchy is an open source E-Ink Smartwatch with an MIT license. Development resources and documentation can be found on the official website watchy.sqfmi.com. There are also several retailers selling the watch hardware. See the documentation for instructions on how to get started with developing for Watchy.
In this guide, you'll learn how to use the LVGL (Light and Versatile Graphics Library) with the ESP32 Cheap Yellow Display board (ESP32-2432S028R). This development board features a 2.8-inch TFT touchscreen LCD, microSD card interface, RGB LED, and more.
The Seeed Studio XIAO ESP32C6 is a cost-effective MCU based on Espressif’s ESP32-C6. This compact MCU excels in Matter-compliant smart home applications with its support for various wireless connectivity (2.4GHz Wi-Fi 6, BLE 5.0, Zigbee, and Thread).
This project guides you through building a real working Star Trek Communicator using FONA Feather and 3D printing.
• The prop can make real cell phone calls using the FONA Feather!
• The device features a vibration motor, speaker, and microphone mounted inside the case.
• You can customize the buttons to call any number you want.
• The 2500mAh battery is rechargeable over USB and will provide several hours of energy.
• The prop can make real cell phone calls using the FONA Feather!
• The device features a vibration motor, speaker, and microphone mounted inside the case.
• You can customize the buttons to call any number you want.
• The 2500mAh battery is rechargeable over USB and will provide several hours of energy.
If your board is never used with ch55xduino before, you need to make the ch55x chip enter bootloader mode. You need to disconnect USB and unpower ch55x, connect the pull-up resistor on D+ line (generally a 10K resistor between D+ and 5V, controlled by a push-button or adjacent pads). Then you connect USB. and hit Upload. Also, a blank new chip will enter the bootloader automatically.
U8X8_GP1287AI_256X50_4W_SW_SPI u8x8(/* clock=*/ 0, /* data=*/ 2, /* cs=*/ 14, /* dc=*/ 4, /* reset=*/16);
